Machine Introduction.
Professional STRYKER used wire cutting and stripping machine ST-KOF is mainly used to strip copper core and plastic sheath Wire diameter range of this copper stripping machine is 1-60mm, also has fast processing speed and high stripping efficiency and is widely used in scrapyard, cable factories, and all types of recycling businesses. This cheap cable stripper machine can strip all kinds of scrap wire or cable. very useful for scrap recycling
*Specification.
Suitable for wires ranging from 1 to 60mm * either solid or stranded
Eleven (11)standard channels for round wires
Two (2)dedicated flat wires.
Two (2) Slitting channels for pressing wires
Powerful 2.2KW motor runs off any wall outlet (110-120VAC)
Stripping speed: 30m per minute.
Adjustable Tension works with different insulation, soft or hard
Double-Cut Mechanism gets the copper out in just one pass.
Dimensions: 760x64 x92mm
Model | ST-KOF |
Processing Range | 1 to 60mm |
Dimensions | 760*640*920mm |
Gross Weight | 135KG |
Net Weight | 115KG |
Power | 2.2KW |
Output | 600-2800KG/DAY |
Voltage | Customized |
Warranty | 12 months |
Operating(instruction)Manual.
1. Push Switch up to turn Motor ON. Check whether machine works well. Make sure there are no people on the output side of machine.
Comparing cables wires diameters with feeding slots on machine, feeding cables/wires one piece. Before feeding cables/wires, please cut off cables/wires' head to avoid gaps caused to blades
2. On the output side, if cuts on cables/wires are too deep, please check below points Please adjust handles on input side, screw down or lose them. (M12 handles).
Check whether cables/wires on right position as you are feeding them.
Make sure blades are sharp if not, polish them with oil stone
3. On output side, if see plastic ( PVC ) has been stripped, but copper wires can not be disgorged, please check below 4 points. Check whether springs are loose. lf yes, screw down to make them tighten. The diameter of cables/wires are too small.
Please adjust space between two axes to 0 3-0.6mm.
If cables/wires you want to strip are hot, you also can not get copper wires stripped out.
4. lf cables/wires were blocked in axes, please check below points
check if Chains are loose.
②lf springs on the press wheels are too tight, lose them There is too much oil on cables/wires, Please wipe it (make sure machine is turned off before wiping.)
Make sure wires' diameter are similar with feeding slots, large cables/wires in large feeding holes, small cables/wires in small feeding slots, flat cables/wires in flat feeding slots
Different View Pictures:
One set used wire cutting and stripping machine KOF can not be shipped by sea. We ship the machine by sea depending on machine weight 250KG at least, so we recommend your buy more shipping by sea
STRYKER EQUIPMENT Aftersale Service
1: Overseas technical support available.
Name: Ian Smith
Mobile:0086 19991805031
Tel:0086 19991805031
Whatsapp:8619991805031
Email:ian@strykermachinery.com
Add:Room 1002, Building 10, District 2, Duyong Village, Changxiang Street, Chang'an District, Xi'an, Shanxi Province